Can a trolling motor run out of water?

Your motor is cooled by the water around it, while running it out of the water for a very short time would be OK, it would take a long time to drain the battery much running the motor out of the water with no load. Why risk damaging a very expensive TM to just drain the battery down.

How long can you run a trolling motor?

Almost 5 hours doesn’t seem too bad, but that is really a max runtime in ideal conditions. Reality is likely to be less. If the battery is old, damaged or not fully charged then you will not get the rated amp hours from it, reducing your runtime. Significant cold or hot weather will also reduce your runtime.

Can a trolling motor burn out?

John stated….. “The major cause of a trolling motor burning out is low battery voltage, line behind prop, or anything else that causes the prop to turn slower than it should. this causes more of a “short” and generates the heat that burns wiring, solder joints, and switches.”

THIS IS INTERESTING:  How do you check transmission fluid on a Chevy Impala?

How far should my trolling motor be in the water?

The rule of thumb is that the top of the motor section should be submerged 12″. In general, shaft length selection is more critical with bow-mount motors versus transom-mount motors. Most boat transoms are similar in their distance to the water, and Minn Kota’s standard transom shaft lengths should be adequate.

Can I use a car battery for my trolling motor?

deep discharge cycling a car battery (using it for a trolling motor) will ruin it rather quickly. a trolling motor battery is designed to deliver a modest amount of current for a longer period of time. it is designed to tolerate deep discharge/recharge cycles.

How can I speed up my trolling motor?

Make Your Trolling Motor Faster

  1. Make Your Trolling Motor Faster.
  2. Change the Battery.
  3. Reduce the Load of the Canoe.
  4. Fix a more Streamlined Propeller.
  5. Put on Lighter Attire.
  6. Replace the Existing Motor.
  7. Conclusion.

How do you measure a trolling motor shaft?

The shaft length on a trolling motor is measured from the base of the motor head down the the top of the motor compartment.

What is the strongest trolling motor?

Minn Kota has introduced the most powerful trolling motor on the market featuring 112 pounds of thrust.

How do you know if your outboard is too high?

Too high usually results in low water pressure, prop letting go in turns, or lack of bow lift are usually the telltale signs. Sometimes porpoising is caused by too much bow lift and dropping the motor will give it more bite and make it worse.

THIS IS INTERESTING:  Frequent question: Is towing hard on a transmission?

How far below a boat should the prop be?

If you have a short shaft motor, the top most part of the transom and the lower most part of the boat should be about 15 to 16 inches. For a long shaft, I think 20 to 21 inches is correct.

How do you clean a Minn Kota trolling motor?

Grab a bottle of Pledge® multipurpose cleaner, Armor All®, or another water-based* silicone spray and apply some spray to a soft cloth, and wipe down the composite trolling motor shaft. This lubrication helps ensure smooth deployment and stowing of your trolling motor, especially on electric steer motors.

How do I know if my trolling motor battery is bad?

Repeat ever couple of hours or when you notice a power drop. If one battery drops more than the others, that one is probably bad. If the batteries are being charged fully, start the day at the same voltage and discharge equally, then they are probably all worn out. Just a regular voltmeter.